Search results

Now the castle style nut has come apart from the rest on the BSE Pitpro has a 320/22 cup on the bottom ... And 320/22 bearing

Carby arrived, a lot smaller than mine 20.7 v 24.7 Manifold side, 31.8 v 36.8 filter side Got all my stem bearings (would not recommend seller tdpro99) - the top bearing cup (320/22) spins freely in the stem before assembly, is that normal?? Anddd I've forgotten how the washers were in the...

Hard to describe (for me) The edge to edge varies up to 5mm at some spots

The rear rim on the bse frame, I noticed a buckle in it when I first got it home - took the tyre off today (reasonable tread Kenda Carlsbad) and noticed it has a lot Will take a pic tomorrow So take the rim off the market

Craig, just had a thought - perhaps I could swap the hubs over from the bent rim I have here into the new one?

New stem bearings arrived for middle frame - missing the 320/22 cup :( Clutch cable arrived Levers didnt, Throttle cable didnt I think I will take the forks off the pitpro and give the frame a quick coat, change stem bearings - want to put the BSE forks back on that frame before I do though...

2 Bearings, 1 Cup - :boink: eBayer

Bushes fit :thumbup:

I've only taken this one apart down to the frame + forks - and just washed them Didn't want to go further so I wouldn't find more things to buy Haven't tried your bushes yet, have to clean up inside the cases a bit first so they don't get ruined

Got the ** bushes out, they're dead jim

Ahh, I didn't think there was any steel in mine, but I can just see it - looks very thin though, not getting any purchase with screw driver Got seal kit and exhaust from DASSA Cables and levers still in post Not sure when I'll be able to get down

New mount, 8mm holes fits M12

I'll definitely grab the manifold. Will bring down that wheel when I pick it up Have sent the guy a message.

Hmm, don't suppose there's a chance you could take a look for me? I won't be in town till the weekend with this weather How much do you want for the manifold?

http://www.gumtree.com.au/s-ad/beverley/parts/150cc-pitbike-engine-/1066712837 :\

Would DASSA have offset manifolds?

Well I've certainly over worried this, In the end the pad/caliper suits 190mm, bottom of pad will go the top of the ^ no matter what rotor is used (34mm pad depth) And I did put a 190 on the front, I just got confused as I have too many rotors around.

Ugh, I've had a bad day with measuring Thought I had the front sorted, I measured 95mm from top pad edge to axle centre... then preceded to put the 180mm on :hidesbehindsofa: - will fix moro Are the wave rotors preferred over the full rounds? And do the waves need to be specific directions...

Rear PitPro 180mm Pads Front PitPro 190mm I have those and 190 + 210mm Rounds Also, I assume there's no reason to keep this any more?

Indeed it was/is Looks a bit old gen though