Search results

Got a mates pw50 to compare mine too. Tested the stator and CDI and all good. Someone else mentioned that it looks like fuel starvation, so I though I would check out the fuel tap as there's a filter in there. While draining the tank from the hose that I popped off the carb, I noticed that the...

I had cleaned the jets and tested the float. The level also looked fine. I suspect it has something to do with heat as it only happens when the bike has been running for a few minutes. It's almost like it heat seizes. I might see if I can get hold of another carb from a mates one and see if that...

Picked up a 2013 PW50. Bike runs for about 5 minutes then just bogs and cuts out. Won't start for awhile, but then will fire back up. I've checked the spark plug after it dies and it's dry, so don't think it's a flooding issue. So far I've replaced the spark plug and air filter. Stripped and...

Where about do you ride? I landed up selling my klx as not many good places to ride (that I know of) where you aren't sharing the track with full size bikes. Gap Creek has a nice pitbike track, but just a bit far... Also I don't see many mini's these days at QMP or Willowbank MX.

Nice build!

Sweet looking ride you got there mate

Brisbane, looks like 8.5 hours away from Newcastle.

A few things to check in addition to what you've done: - Check for week spark. There are a few youtube vids showing the difference in spark. - Strip the start/run switch and clean out with contact cleaner (this was the problem I had). You can also by bridge the the connector to rule that problem...

I'd be interested if you weren't so far away...

I think any paint will wear through, just at different rates. Use a high temp paint like vht or similar, make sure surface is preped well. Apply thin coats, and make sure you bake it afterwards. If the misses won't let you use the oven, either throw it on the bbq or wait for her to go out and...

Sweet looking LXR you got there.

Yeah thought of entering the KLX, but bars, cradle, pegs, shifter and some stickers aren't worthy for FOTM...

INSANE https://www.youtube.com/watch?v=EvL6_CsH90A

That's a nice setup!

Anyone know where I can source a 1" extended gear shifter for a KLX 110 locally? Couldn't find one on DHZ or buzz bikes. MXStore has the hammerhead but I think it's stock length. Got a few parts on the way from TboltUSA and figured I'll just get an extended one from them, but $60USD...

Well went with the KLX bend. Figured I could always add bar risers or change the top clamp.

Nice bike, dig that colour.

Looking to change the stock bars to a set of pro tapers. Been trawling through the forum to get an idea on people's opinion of the XR50 vs the KLX110 bend but haven't found anything of value. Anyone out there used both? Don't want to waste coin on the wrong set. I'm about 5.8, would the KLX...

Looks awesome!

Cordogs, what coating did you use on the floor?