rear shock

Mini Dirt Bikes & Pit Bikes Forum

Help Support Mini Dirt Bikes & Pit Bikes Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. S

    Will this shock fit my 50 (crf50 kinda style)

    DNM Rear Shock MK-AR-240L 600lbs Spring – DNM – Buy Online Australia at DHZ
  2. A

    crf50

    hey guys just wondering if this DNM rear shock i bought will fit a standard style swingarm on my completely stock 2012 crf50
  3. S

    Couple of questions about the new rear shock for PitPro 2008

    Ok so firstly....this gap! Should I be getting some washers to stop it moving around or does it not matter? Photo 1 the gap Besides from that the new shock is 290mm fits fine so no probs there. The stroke is 66 or 67mm which should increase the rear travel a little. Now I guess the geometry...
  4. motorman

    Rebuilding Zhocci's and Elka

    Hey all, Looking at getting both my zhocci's and elka rebuilt. Got a bloke that can do it for me. Just not sure where I can get new seals etc for them? Going to start stipping the bike back tomoz night for a heap of TLC. Will get a build thread up shortly.
  5. T

    chect to see if rear shock holds pressure

    hi my son just got a new 125 n i checked the rear shockie pressuer of the nitrogen but its empty the shaft has no rust n the seal isnt leaking can i pump a few psi of air in it to see if it holds b4 i get it regassed as they want over $35 to put nitrogen in it n if its going to leak id rather...
  6. Defective

    Suspension Basics - Setup and Troubleshooting guide

    I was reading a thread on here discussing linkage and non linkage suspension setups on both pit bikes and the 2011 KTM's so I clicked on a couple links to read more about it when I came across this suspension tuning and troubleshooting guide. It was written for/by WP suspension but the same...
  7. C

    Suspension upgrade

    HI CREW I AM ABOUT TO UPGRADE THE FRONT FORKS AND REAR SHOCK ON MY ATOMIK 160cc BIGFOOT SO I CAN START GETTING SOME AIR. I AM LOOKING AT DNM HRC REAR AND M-200 FRONT. JUST WANT TO KNOW HOW TO BE SURE I HAVE THE RIGHT MEASUREMENTS WHEN ORDERING. I THINK THE FRONT FORKS ARE 730mm MEASURING FROM...
Back
Top