screw

I need some help with the fork bleeder screw on a nitro circus lxr my son has lost them does anyone know the size of them an the tread type I spoke to dhz they said they don't sell them so I'm going to have to buy a set of fork bleeders to replace them

Hi I'm new to the site found it whilst looking up mods to do to my crf50 :laughing-smiley-002 anyways i have a question i have recently put a lifan 125cc in my crf50 frame and what i believe to be a 30mm carb have to rise fuel tank to fit it on the bike lol when i use gps speedo to see how...

Bought a 24mm with powerjet oko copy recently. Then bought a 100 main jet and 36 pilot jet. the throttle response is much better than the mikuni 26mm (from DHZ) but there is a problem with the idle. It is idle very high (>3000rpm vs 2000rpm with the mikuni), the idling screw all the way...

WANTED:OKO Flatslide Idle screw, preferably with spring CONDITION:Best as possible, thread must be clean PREFERRED PRICE RANGE:0-10 LOCATION:2480 EXTRA INFORMATION: none CONTACT: PM or here

hi there guys i have just replaced piston and rings in my 150cc now it wont start :\ while i had it apart i turned a screw on the side of the cylinder that controlled the cam before realising what it done... yes i know stupid move lol my question is would turning that screw cause the motor not...

Hey guys, I used to be on the forum a few years ago under "Lochie125" But ive forgotten my password and e-mail address to the account :/ I had my carby cleaned and Reconditioned by someone, so it had the air/fuel mixture screw taken out and cleaned, my problem is, it is under the carby...

here is a rusty Jianshe Coyote PY80 i have just picked up it is a china copy of the world famous Yamaha PW80. i bought this one cheap, paid $110 for it as is it has been sitting outside on someones verandah for the last few years, and has developed a Tin Worm infection (surface rust) i...