I have an Apollo 250cc dirt bike I removed the wiring harness from the electric start to only run kick start now I get no spark..I know I only need the cdi, coil, and kill switch I have the coil and kill switch wired as well as the grounds. I still have the blue/white and black/red on the cdi and the wires from my stator are 2 yellows 1 blue/white and 1 green.. Please help
6 pin cdi help
- Thread starter Jamesb
- Start date
Help Support Mini Dirt Bikes & Pit Bikes Forum:
my67xr
Miniriders Legend and Master Spanner Spinning Mode
Welcome to Minirider's.
Sound's like this is the diagram you need,
Black w/white is for the kill switch
Blue w/white is the pick up coil from stator to cdi
Black w/red is Source coil from stator to cdi
Black w/yellow is for the ignition coil
Green is earth from stator to cdi and ground on the frame
The 2x yellow's are for the battery charge/lighting coil and run to a full wave regulator rectifier
They usually look like this-
Or this
Sound's like this is the diagram you need,
Black w/white is for the kill switch
Blue w/white is the pick up coil from stator to cdi
Black w/red is Source coil from stator to cdi
Black w/yellow is for the ignition coil
Green is earth from stator to cdi and ground on the frame
The 2x yellow's are for the battery charge/lighting coil and run to a full wave regulator rectifier
They usually look like this-
Or this
Last edited:
