Bike won't start. Right plug? Which Fuel inlet hole? What else?

[LOL]

Hey guys, my bike will not start, the mods are inner rotor, and lightened oil sling.

-I have checked for spark and have found one (but it is yellow/orange..is a strong spark supposed to be blue?)
-Compression is there.
-Carb has been cleaned, jets, float etc.

So i have spark and compression, i'm assuming it's fuel. On my carby there is 3 holes, i'm unsure which one is for the fuel inlet? could anyone help?

Picture 1

Really bad picture..but it's the hole thats vertical (theres only 1)

I don't think it is this hole because as soon as i put the fuel line into this hole, fuel would piss out of the bottom of the carb (where the float is)

Picture 2

This is the one i have it in at the moment, but the bike isn't starting. I think that there is fuel going into the engine though, because the plug is damp, and i could smell it. When i tip the bike on its side, fuel pisses out of the air filter.

Picture 3

I'm pretty sure this is just the bleed hole? so this can't be the right one right?

Now, i'm guessing it could be the spark plug because i am only getting a yellow spark, which seems to be quite week...The plug i am using NGK C7HSA i think, is this the right plug?

What else could it be guys? i'm about to go crazy. (sorry about bad picture guys, phone was being gay)

 

[daniel40]

the number on your sparkplug would be ok but you might have a faluty one get the same but new

 

[motoluver]

Should be a nice blue spark. Try putting a new plug in.

 

[THUMPY125]

yeah the spark is defiantly meant to be a nice blue colour.

 

[daniel40]

if your old spark plug works try put that in and see if it starts

 

[cass38a]

Check out the carby manual up the top of teck talk it will explain it all.