exhaust for motovert rx 125

[Dabomb]

hey bros, what exhuast should i run/will fit a motovert rx?
do the crf pipes like fmf and bbr fit?

cheers!

 

[unit_mx]

yeh bro , any crf50 pipe will do

 

[wogtaz ryder]

The only thing that mite not work is the rear mounting hole on the subframe , but it isnt hard to make up a bracket or something

 

[unit_mx]

Or use a ttr50 pipe , the mount is further up the pipe

 

[wogtaz ryder]

yer crf50 ones are close on some frames but theres a really small chance it will be spot on mine was probably 5mm off on 1 of my frames and probably 20-30mm off on my other frame

 

[Dabomb]

yeh bro , any crf50 pipe will do

are you 100% sure?

 

[unit_mx]

Yeh bro , bet my life on it!

Depending on the length of the subframe or header pipe you may need a hydraulic clamp / wrap to mount it correctly. But the header pipe will mount no worries to the head , even the ttr50's do.

Shoulda kept your bbr ceramic for it ay?

 

[East50s]

Hi Dabomb.
The usual Pro circuit copies inc H bomb ehausts etc. will fit,but remember you are making the bike louder and illegal for road use !!

Ps. The std exhaust with restrictor in place chokes the bejesus outta the poor motor ..

Cheers Brian

 

[unit_mx]

Staintune will still remain under DB limit , Just get a system with a longer muffler to cut down the noise.

 

[Dabomb]

loudness doesnt phase me!
thinking a bbr or fmf, would these have a to smaller diameter for a 146 cylinder?

 

[unit_mx]

bbr ceramic way too small , but the d section will work good. Fmf 4.1 would be the go , powercore 2 would be **** , way to small header.

 

[Dabomb]

would one of those ones off ebay 32 or 45mm be bigger than the d-section or fmf 4.1?

 

[Dabomb]

will this be adequate?

http://www.miniriders.com.au/forum/mini-chat/19484-exhaust-motovert-rx-125-a.html#post185150