Please read everthing to understand the problem
Hello.. I have Sachs Dirty Devil 125 CR (FYM125 Engine).. I replaced crankshaft.. First of all I don't know english very well.. So.. I had 2 spacers and I forgot where they have been.. I installed basket and I put those 2 spacers under the basked and I installed clutches, I haven't been able to spin the wheel in neutral gear.. Ok, I uninstalled everything and removed thicker spacer and fatter one was left under the basket.. When I closed everything, I was able to move my bike in neutral but I wasn't able to move it in gear with clutch pulled (engine off).. I opened it again and put thicker spacer and removed fatter one.. When I closed it again, I was able to move it in neutral and in gear with clutch pulled but when I start engine, get it in gear and slowly releasing, bike doesn't start to move gently, I don't know how to explain.. It doesn't slip, like it is too hard, I don't know is this word correct but bike is stuttering, won't start to move gently..I completly removed spacers under the basket and when I closed everthing, I wasn't able to move bike in gear with clutch pulled and engine off.. I have 1 spacer for nut, security pins, 1 spacer with teeth, and those 2 more which I don't know where they go.. On one photo I showed those 2 spacers, left one is fatter and right one is thicker.. Thanks everyone in advice!
Sent from my SM-G950N using Tapatalk
Hello.. I have Sachs Dirty Devil 125 CR (FYM125 Engine).. I replaced crankshaft.. First of all I don't know english very well.. So.. I had 2 spacers and I forgot where they have been.. I installed basket and I put those 2 spacers under the basked and I installed clutches, I haven't been able to spin the wheel in neutral gear.. Ok, I uninstalled everything and removed thicker spacer and fatter one was left under the basket.. When I closed everything, I was able to move my bike in neutral but I wasn't able to move it in gear with clutch pulled (engine off).. I opened it again and put thicker spacer and removed fatter one.. When I closed it again, I was able to move it in neutral and in gear with clutch pulled but when I start engine, get it in gear and slowly releasing, bike doesn't start to move gently, I don't know how to explain.. It doesn't slip, like it is too hard, I don't know is this word correct but bike is stuttering, won't start to move gently..I completly removed spacers under the basket and when I closed everthing, I wasn't able to move bike in gear with clutch pulled and engine off.. I have 1 spacer for nut, security pins, 1 spacer with teeth, and those 2 more which I don't know where they go.. On one photo I showed those 2 spacers, left one is fatter and right one is thicker.. Thanks everyone in advice!
Sent from my SM-G950N using Tapatalk
