LXR oko26mm problems:(

[B-Rad]

Heyy
Ive got a lxr 155z with oko 26mm carb. when i got to start it sometimes it makes a pop noise out of the carb and then a poof of grey smoke comes out. and when im ridin and quickly hit the throttle it bog really bad and sometimes stalls????
Any help, i dont know much about carbs
Thanks

 

[billyxx]

backfire, needs a tune

 

[B-Rad]

heyy
can u explain how i can do this?
Cheers

 

[DHZ_XR8cing]

Check your valve clearances

 

[B-Rad]

yer i did my valves this mornin, but it was doin it before i did my valves too????
Any help?

 

[wogtaz ryder]

mis read coz im a dumb ass

 

[DHZ_XR8cing]

What jets you running? What work is done to the engine? What slot do you have the clip on the slide needle?

 

[B-Rad]

well it seems to be only doin it sometimes and it only seems to start doin it when its be ridin for 10mins?
The engine is stock, and i have no idea wat jets are in it just the stock ones

 

[motovert24]

take off the carby and check if its got dirt or water, and get a flat head screw driver to take the 2 gold things (jets and ploit ) and look on the side that will tell you what size it is. my lxr had the same prob but it has a 28mm kelein with 152 jet and 42 ploit (way to big)

 

[sean01]

sounds like just a needle height adjustment needed..

move the needle clip 1 clip down and try, if a little better but not perfect then go another clip down..

 

[B-Rad]

sounds like just a needle height adjustment needed..

move the needle clip 1 clip down and try, if a little better but not perfect then go another clip down..

Thanks heaps sean01 It seems to be workin, hopefully it stays that way

 

[B-Rad]

Ok so now that i changed the needle height, it doesnt want to start it starts for like a second and then dies, even if i rev it it just dies
Help

 

[DHZ_XR8cing]

Did you just move the needle 1 slot? Didnt you do it and say it worked?

 

[B-Rad]

its all good now, i flushed the carb and changed the fuel filter