Mikuni fuel screw

[DustyFork]

Dose anyone know where to get a extended fuel mix screw for mikuni 26mm if there is one that exists. Gettin annoyed of having to pull carby off to turn screw!!!!

 

[rotn50]

I have always thought of getting a little t-piece of brass rod braised to the existing fuel screw, there an absolute pain in the butthole and the design is a joke, a typical china ****up. But no mate i dont know where.

 

[zwebx]

FLex Jet - Pit Bike Engine Parts - CARBS and JETS - WHS-1612 - TBolt USA, LLC
prolly best off buying a oko or a vm 26

 

[DustyFork]

Wow 35 bucks is a bit steep! I might just get a new carb. One with easier access to screw. There's another prob what size I need there are so many option and sizes

 

[8r3nd0]

Get a small ****ty flathead screw drive put it in a vice and bash it over with a hammer that's what I did when tuning a mates 110.

 

[zwebx]

i did that, but i could only turn the screw 1/4th of the way and now i wonder why i waisted a screwdriver

 

[my67xr]

i just use a #3 flat headed driver bit,

flat driver bit - Bing Images

 

[rotn50]

The T-bolt flexible screws are a bit steep but the money I have spent on other parts not as important as something like this isn't comparable. There would probably be a tiny percentage of mikuni 26 and 30mm carb owners that have a tuned carb and will never know what the potential of this part could have. I would grab one no probs if I ran those carbs. And I wouldn't have the patience for trying to tune it. I'm lazy