SSR 125 throttle cable length ?
- Thread starter Steven_W
- Start date
Help Support Mini Dirt Bikes & Pit Bikes Forum:
my67xr
Miniriders Legend and Master Spanner Spinning Mode
Welcome to Minirider's
First up, drop in here and Introduce Yourself.
It all depend's on what size the bike is, crf50 style, crf70 style etc, and what type of throttle it has too
Some cable have a straight end at the throttle, some have a 90° end at the throttle
Can you compare the length of your cable to this one ?
TB Throttle Cable for 26mm carbs KLX110 DRZ110 - TBW0321 - Carb Kits & Throttle Cables - Pit Bike Engine Parts - TBolt USA, LLC
Amazon.com: 28" Dirt Bike Throttle Cable Parts Pit Bike SDG SSR Parts Roketa 50cc-125cc: Automotive
Take your air filter off and look down into the carby throat, if the slide is sitting up off the bottom of the bore it might just be that the slide has been fitted back in 180° out
Try undoing the top of the carby and lift the slide out, look at the 1/4 moon shaped cut away on the bottom of the slide, that need's to face the air filter side of the carby
If it was facing the manifold side then it will be revving flat out when it's started.
You need to line up the long slot in the slide with a pin in the slides' bore of the carby for the slide to slip down and back in properly.
Do up the top and see if the slide has dropped to the bottom of the carby bore, (a few mm's up from the bottom)
Also check that the idle speed screw (central to the tower part of the carby) hasn't been wound in too far and is holding the slide too high
Post up your finding's
Cheer's, Craig
First up, drop in here and Introduce Yourself.
It all depend's on what size the bike is, crf50 style, crf70 style etc, and what type of throttle it has too
Some cable have a straight end at the throttle, some have a 90° end at the throttle
Can you compare the length of your cable to this one ?
TB Throttle Cable for 26mm carbs KLX110 DRZ110 - TBW0321 - Carb Kits & Throttle Cables - Pit Bike Engine Parts - TBolt USA, LLC
Amazon.com: 28" Dirt Bike Throttle Cable Parts Pit Bike SDG SSR Parts Roketa 50cc-125cc: Automotive
Take your air filter off and look down into the carby throat, if the slide is sitting up off the bottom of the bore it might just be that the slide has been fitted back in 180° out
Try undoing the top of the carby and lift the slide out, look at the 1/4 moon shaped cut away on the bottom of the slide, that need's to face the air filter side of the carby
If it was facing the manifold side then it will be revving flat out when it's started.
You need to line up the long slot in the slide with a pin in the slides' bore of the carby for the slide to slip down and back in properly.
Do up the top and see if the slide has dropped to the bottom of the carby bore, (a few mm's up from the bottom)
Also check that the idle speed screw (central to the tower part of the carby) hasn't been wound in too far and is holding the slide too high
Post up your finding's
Cheer's, Craig