bike hard to roll :(

[Chickenwingz]

my bike is hard to roll with the clutch pulled in 1st gear, the bike also moves a bit by itself in 1st gear with the clutch in. I recently changed my clutch lever but i also adjusted it to pull in as much as it can so i don't think that is the problem.

 

[zwebx]

Try adjusting it again but with minimal freeplay..
maybe its time to inspect the clutch how many hours is on her?

 

[Chickenwingz]

Alot of hours.

 

[Chickenwingz]

Does the new 6 plate clutch go in the old 5 plate 155z's?

 

[8r3nd0]

Why are you rolling it in gear, if you mean roll/bump start if it's been sitting a while the clutch would of dried a bit and just needs some oil to circulate to free it up.

 

[my67xr]

the clutch lever should have approx 5mm play/movement before it starts to disengage the clutch.
otherwise it can burn/wear the clutch plates out.


i'm pretty sure the 6 plate setup will fit onto the the 150/155/160's engines, that originally had the 5 plate clutch fitted.

 

[zwebx]

Does the new 6 plate clutch go in the old 5 plate 155z's?

I cant see why not..
maybe ask terry from firepower minis he will know
the 6 plates are good as you can see in one of my videos 4th gear redline it had enough strength to spin the wheel and then stall it

 

[nickv1980]

It's munted get a new one 6 plate all the way

Sent from my HTC_PN071 using Tapatalk 4