Can't get my semi-auto into gear

[ollie_69_96]

Hey i'm new to this forum and new to pit bikes.
I recently bought a 110cc pit pro and can't get it into gear, is there something wrong with my bike or am I not doing it properly.
can someone tell me exactly how to do it properly.
Cheers
ps sorry bout the stupid question

 

[pascal125]

Hey mate, Yeh i saw you bidding on a dozen pitpro 110's. Good that you won one. Pitpro 110's are difficult to get into gear, try a longer lever for extra leverage or pull it up with hand a few dozen times to see if it will loosen up??
Good Luck.

 

[ollie_69_96]

yer that was me, i ended up getting the bike for $365 plus 85 postage and 30 insurance.
thanxs for the tip i will try that later
cheers

 

[ollie_69_96]

thanx pascal125 I did what u said and i got it into gear first time.
but my only other problem now is i can't get the engine oil drainer bolt off to change the oil that came with the bike.
I will post up some pictures of the bike later
Cheers

 

[pascal125]

Hey mate, for my bike it is a 17mm socket, a spanner will fit in there but won't get enough leverage with the angle.
They tighten most of them ALOT when they come outta the factory, i couldn't undo mine and had to get my old man too, lol.
Good Luck.

 

[darb110]

yeh they can be bloody tight some times man i can remeber one time we were trying to get a blokes off and it was no dout undoable =P haha just get a socket onto it and to be honest its just shear muscle just put your guns to work =) good luck champ!

 

[ollie_69_96]

I got i bolt undone, it actually wasnt that hard after all.
at least the bike is all good now and ready for use just need to run her in now.

 

[M@rkay]

good you got your bike going again