Cheapest and best upgrade for your 125

[geezus18]

Hey guys,
I rode my atomik avenger for the first time in two months (busted rear hub...neaded a new one) today. I bought a 37 tooth rear sprocket just after my hub shat itself and ive finally been able to test it out. It pretty much makes each gear twice as long and increases the top speed shit loads. Its (in my opinion) the best upgrade for ya 125 for the cost. If anyone else has wakked one of these on tell us what ya think of it!

 

[Dirt Bikez & Pocket B]

yep the 37t sprocket is difinately the bang for your buck.

 

[SEDUCE]

Hey Mate Where U Get Them From Cause I Rode My Wifes Avenger And I Think The Same They Are Really Shit Down Low And Need More
Also How Much Was It

 

[geezus18]

i got mine from elstars.com.au for $25 not including postage..not sure how much postage was. But they are a good dealer and sell a whole range of things.

 

[SEDUCE]

do u know what the measurements were for it from hole to hole???

 

[geezus18]

well if it fit my avenger it'l fit yours...im not sure about the measurements i think it was 69.9 mm from hole to hole.

 

[SEDUCE]

hey mate i just measured my wifes rear sprocket from bolt hole to bolt hole was like 90mm ??? is that right?

 

[geezus18]

what model atomik do you have...do you have a picture of it?

 

[SEDUCE]

yeah mate this is the bike here

 

[geezus18]

these are the measurments of my old stock sprocket and my new 37 tooth sprocket on my avenger:
bolt hole to bolt hole (measuring from the centre of the smaller hole to the centre of the opposite small hole) : nearly 70mm
centre hole (big middle one): about 55mm

 

[Dirt Bikez & Pocket B]

will the elstars 37t sprocket fit that bike. ^^^^ i have the slightly older model (no usd forks) my old sprocket snapped.

 

[geezus18]

Well it should because i have an atomik avenger and it fit snug on mine, but im not sure whats goin on when SEDUCE says that the distance between theyre bolt holes is like 90 mil...probably an incorrect measurement because they should all (avengers) be the same. just measure your old sprocket (if u can lol....seeming how its snapped) and let my know the measurements.

p.s. how'd ya sprocket snap?

 

[Bones]

i would have to aggree, i threw on a 17t front and a 37t rear and she bites now, of course not as much bottom end but top end is vicious and bottom end was huge to begin with so this brought it back into line a little . she is the best for $35 total.

 

[crazzy #1]

and the decent chain for $44.00

 

[Bradpit]

Hi all i have an Atomik Motox 125 and i also measured the rear sprocket, bolt to bolt is 90mm and hub is 110mm, rang atomik yesterday for parts and apart from hardly understanding the guy, they cant get a 37 tooth rear sproket, piss poor parts service but not a bad bike to fuck around on.