Hydraulic clutch

Mini Dirt Bikes & Pit Bikes Forum

Help Support Mini Dirt Bikes & Pit Bikes Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
the pull rod might be a touch shorter going by his picture? but it might just be the angle the pic is taken at too ?

also if you zoom in on the used Magura set up, the Slave Cylinders' the rubber boot looks wet ?
might need a new seal ?


and your whether it fits or not question,
this new Magura slave cylinder say's it fits the YZF450,and CRF450
CRF250 450 DRZ400 YZ250F YZ426F YFZ450 Magura Hymec Slave Cylinder Brand NEW | eBay
this is the cylinder that nickv1980 has used (i'm pretty sure ?) and says it fits the YZF450 too
CRF150 KX85 250 500 KDX200 220 YZ125 250 Magura Hymec Slave Cylinder Brand NEW | eBay

i think you would need to make a custom bracket to adapt it to fit any of the rear clutched Pit Bike engines
 
this pic shows how nick has mounted his to the engine
the Daytona and Lifan 150 use a different mount to the YX160's too

P1040468_zpsa19b2036.jpg
 
Last edited:
Back
Top