motovert 125cc rear brakes

[lukelacey11]

hi im new to this i was wondering if anybody could help me with a problem i have at the moment with my 2010 Motovert 125cc.. The rear brakes pedal has no resistance at all, ive bled the oil and refilled it twice now, i was wondering if anybody would know how to resolve the problem?

 

[my67xr]

hi, welcome to the forums,

sounds like there is air still in the system .

it might be easier to fill the resevoir, put the cap on and have it lower than the caliper.
pump the master a few times on the ground and bleed off any air at the bleeder on the caliper.
do this a couple of times, then refill the resevoir.
bleed it again with the master lower than the caliper.

then refill it and bolt it back to the frame.

it should come good.
let us know how you go.
and give us as many details as you can, it may be in the way you are doing it

cheers, craig

 

[lukelacey11]

alright ill give that a go thanks mate

 

[coolmodee01]

what do you mean by no resistance?

can you push the break peddle all the way down to the peg moun and get nothing???

if so pads are to warn or you haven't blead them right or there's a leak in the line or there adjusted wrong

or

you push on it as hard as you can without it bottoming out??
then the master cylinder is toast and take it back to dommy and get a new one

good luck

 

[lukelacey11]

yeah im pushing the brake pedal down to the floor and nothing is happening, wheel just keeps spinning.. ive bled it twice now and im not sure what the go is..

how do i get the master below the caliper if i gota pump the brake?

 

[lukelacey11]

also, when i bleed it, is it meant to come out in a solid stream?

 

[yzf250rider]

that happen to the rear brakes on my motovert, im pritty sure the piston was seized on mine, the shop also said to reverse bleed the brakes

 

[lukelacey11]

yeah i gona have a fiddle with it maybe tomorrow or on the weekend ill let yous know how it all goes thanks for all the help, appreciated.

 

[motovert24]

make sure the clip on the side is push in correctly, same thing happend to mine and worked after i did that

 

[lukelacey11]

wheres the clip mate?

 

[motovert24]

cant get a pic of it since i don't have the bike at home anymore
but its

around where the red circle is, if its the same brake you'll know when you see it