Plenty of spark but wont start

Mini Dirt Bikes & Pit Bikes Forum

Help Support Mini Dirt Bikes & Pit Bikes Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
hahah ohh really well i best do it when i have someone standing around with the hose cause with my luck knowing i would catch my self and every think else around me on fire lol
 
I agree with the aerostart. Makes starting easy especialy if something is not quite right. Eliminates electrics and engine internals as a problem
 
You can always throw a bit of petrol in a spray bottle, as said, you only need a little so be very careful! :D
 
i have read the whole thread but sounds like the problem isnt fixed?

you said you cleaned the carby? did you take the jets out and clean them with a air compressor?
 
nah thats my next mission 2day to take jets out pull carby right down check every think make sure its in working order and try my luck again so fingers crossed it works other wise i am stuck riding my old moto next weekend up the bush :( which is not fast n fun at all lol
 
no go guys pulled the carby off cleaned it put a bit of fuel down the neck kicked it no got tryed to run start it all i got was the motor kicking over as it rolled down the hill aand as soon as i stoped it stoped pulled to the op the motor off it looks fine any other idears if water was to get in some where where it would be sitting or where else it could be sitting or wat else that water could of damaged or i dont know its got me stumped and annoyed
 
Try pulling the flywheel/rotor cover off.
When we were racing the other week in the rain we had massive electrical problems.
I wasn't aware that water could even get in there, but if you used a pressure washer it can get in easy.
Mainly due to moisture in the rotor. One bike was so bad that within 24 hours it had corroded all the necessary parts to create a spark.
If it is wet in there, wipe of any excess moisture and leave to dry for a few hours.
If it is corroded you will also it around the magnets, wires and flywheel nuts.
 
i need a lot more than that now i undone the case around the kick started now ****ed it and gave up have to try line it all back up 2morrow wat a c**t of a job might just push it down to the tip and dump it or take it to a moto shop

you can dump it at my house rather than the tip plz :)
 
SunnyCoastRider put 2 00 on the end n i may think about it more
MXgirl i have tryed that tryed it wit the cap twisted a bit tryed it off still no go
 
hahahahah

u want 500 for your broken china? hmm
i can get a 140 new for that..
 
I think you need to take it to a shop and get them to check it
 
Im far from experienced ...but sometimes those with plenty of experience forget the basics
 

Latest posts

Back
Top