yx150 stator issues. postie.

[chewyd13]

Ok so ive been building a postie bike for a little while now and i have installed a yx150 engine from a ciniworx 150. Install went well everything ran just fine, but the engine didnt have a charging/lighting circuit. So i bought what i thought was the appropriate magnito/stator off ebay. When i went to install it i realised that it was considerably larger and also vefy few of the wires matched up, i figured out as best i could what was what without an acurate wiring diagram, and after install was complete it would not even come close to starting, and it had one little wire left over that came to a sort of disk that clearly goes into some kind of hole that isnt present on my engine.

Where have i gone wrong here? Photos attached are of engine in bike, new stator, wiring, odd disk thing, and old stator. Any help would be greatly appreciated.

 

[chewyd13]

View attachment 11149View attachment 11149
Old stator.

 

[my67xr]

Welcome to Miniriders,
make sure you drop in and say hello in our Introduce Yourself thread too while you're here.
http://www.miniriders.com/general-chat/20824-introduce-yourself.html


What cdi and wiring are you using on the Postie ?

that green w/red stripe wire is only used in Start in neutral only pitbikes, wont be needed for your postie


Cheers, Craig

 

[chewyd13]

Cheers! Is the green w/red wire going to cause issues for me?
Wiring and cdi is all standard from the ciniworx at this stage.

 

[my67xr]

The green with red stripe wire isn't needed for the postie.
It is hardly used these day's in many pit bikes.


So you have the 8 pin cdi like this fitted now?

If so, then you wont be able to get it running using that and the stator you have bought.
And you might have damaged that 8 pin cdi by wiring it up like you have too.

 

[chewyd13]

Ah i see. Thats no good at all. So will i need a different stator or different cdi?

Thats for your help by the way.

 

[my67xr]

This loom/cdi will work with the stator you have fitted now
5 PIN Ignition CDI Unit Wiring Loom 50 110 125cc PIT Quad Dirt Bike ATV Buggy | eBay

Do you have a regulator/rectifier for the lighting/battery charging circuit?
You'll need one like this if you don't have one- 12V 4 PIN Regulator Rectifier 50cc 90cc 110cc 125cc ATV Dirt Bike Quad PIT PRO | eBay

 

[chewyd13]

Thanks heaps dude, ill let you know how it goes once i install it.

I haven't got any of the lighting/charging circuit yet, want to get the thing running first.