irk screws

[brown-i]

ive finally got the flywheel off but now the screws for the old irk wont come out, ive dowsed them in wd40 left them to sit for a good hour and they still wont budge. anyone else had any trouble with these? i really dont wanna strip them either.

 

[Kingers]

tried an impact driver?

 

[unit_mx]

Impact driver is the only solution.

 

[brown-i]

will bunnings have one or would i go somewhere like supershit?

 

[unit_mx]

Supershit have them for $12 - superworks but does the job

 

[brown-i]

righto, settle pettle i actually watched it just after i made the thread ha.
cheers fellas!
ohhh also i need a wiring diagram for the new irk and cdi. mum threw the original one out. can anyone do it?

 

[SnItChY]

easy peasy

 

[liljohn_92]

oh yea you dont actually need a impact driver like every1 said...

i just used a big phillips head and undid em by hand

 

[unit_mx]

oh yea you dont actually need a impact driver like every1 said...

i just used a big phillips head and undid em by hand

Preety sure he would of tried that. Using a big ol' screw driver is a good way to bur out your ****** china phillips bolts. Must of done a good job at the assembly line on your bike if the bolts arn't tightend up correctly. Honda climan manual states you need an impact driver to remove these components , they copy that so thats what you should need to undo them.

You supposed to use an impact driver to reinstall the bolts aswell.

I wouldnt gamble on ****** china bolts other wise you'll find yourself in all sorts of trouble...

Make sure you run some medium strength threadlock on the fastener thread aswell otherwise they may viabrate out and cause all sorts of nasty problems...

 

[brown-i]

all done, thanks for all your help!definetly need an impact screwdriver