V2 Race head from yx160 to pitsterpro z155

[DustyFork]

Hi all got a yx160 with a bugged bottom end so I got a spare engine which is a pisterpro Z155. Will my V2 race head off my yx160 fit the z155?

 

[timeeh]

Hi all got a yx160 with a bugged bottom end so I got a spare engine which is a pisterpro Z155. Will my V2 race head off my yx160 fit the z155?

Yep she'll bolt straight on, may have to change the piston though?

 

[my67xr]

yeah, what timeeh said.
if you do swap them and use your standard Z155 piston, at least check the valve to piston clearances.
i think they need to have the valve reliefs cut a bit deeper ?

 

[timeeh]

To test you can put plasticine on the head then attach it, rotate the piston a few times (do it slowly in case it bites) and that will give you a good idea of wether or not you need to change

 

[DustyFork]

Sweeeeeeeet I was gunna use my tb race piston out of my yx, same size od 60mm this will be ok yer?
I'm doing a full ground up rebuil on my bike, blasted the frame on the weekend and got the first coat of Kawasaki green on it today. Looks soooooo bloody good. I haven ridden the bike for over 8
Months and been itching to get it going. Sooo worked up at the moment 2 weeks and I shoul be fanging!
Funny what kicks ya get from building bikes!!

 

[DustyFork]

Hmmmmm I'm having a problem with d

 

[Stubsy]

Hmmmmm I'm having a problem with d

so do a lot of women mate, you will be right.

haha sorry I had to

 

[timeeh]

so do a lot of women mate, you will be right.

haha sorry I had to

Touche

.....

 

[DustyFork]

Lol I would have done the same....